- Introduction to WorkXpress
- Building Your Application
- Examples and Best Practices
- Technical Manual
This shows you the differences between two versions of the page.
|
expression function - hyperbolic sine [2016/09/14 18:19] |
expression function - hyperbolic sine [2016/09/14 18:19] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Hyperbolic Sine (Expression Function) ====== | ||
| + | ===== Purpose ===== | ||
| + | The **Hyperbolic Sine** function (SINH) is used to calculate the hyperbolic sine of an angle given in radians, degrees, or gradians. | ||
| + | |||
| + | {{::sinh_initial.png?direct&600|}} | ||
| + | |||
| + | ===== Parameters ===== | ||
| + | The **Hyperbolic Sine** function has two parameters, the first of which is required: | ||
| + | |||
| + | ==== Radians ==== | ||
| + | |||
| + | Allowed Inputs: [[Field|field]] value or number | ||
| + | |||
| + | The first required parameter is the angle that the hyperbolic sine will be obtained from either use the use the [[Query Builder]] to choose a field that contains the value or use type a value to enter a number. | ||
| + | |||
| + | ==== Angle Unit ==== | ||
| + | |||
| + | Allowed Inputs: omitted, 'd', 'g' | ||
| + | |||
| + | The second parameter of the **Hyperbolic Sine** function is the unit the angle is provided in. If the angle unit is omitted or not recognized then radians will be be used. For an angle provided in degrees use 'd'. For an angle provided in gradians use 'g'. If the angle unit needs to be dynamically stored in a field then the advanced expression builder will need to be used. | ||
| + | |||
| + | |||
| + | ===== Output ===== | ||
| + | |||
| + | The output of the **Hyperbolic Sine** function is a number representing the horizontal run of an angle where in intersects with the unit hyperbola. | ||
| + | |||
| + | ===== Example ===== | ||
| + | |||
| + | For example SINH(0.5235987755983), SINH(30,'d'), and SINH(33.3333333333,'g') would result in "0.547853473888". | ||
